WARNING:
Be extremely careful when removing the lamp housing. In the unlikely event that the bulb ruptures, small glass fragments may be generated. The lamp housing is designed to contain these frag- ments, but use caution when removing the lamp housing. Before replacing the lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement. This prod- uct has a lamp which contains a very small amount of mercury. Dis- pose of it as required by local, state or federal ordinances and regulations. For more information see www.eiae.org.
5Detach the lamp connector from the projector by depressing the locking tab on the connector and lightly pulling it free.
6Loosen the captive screw that attaches the lamp housing to the projector. Carefully remove the lamp housing. Dispose of the lamp in an environ- mentally proper manner.
7Install the new lamp housing and tighten the screw.
8
9Replace the lamp door by sliding it into place. Be sure the lamp connec- tor wires are not in the way.
10Plug in the power cord and press the Power button to turn the projector back on.
11To reset the lamp hour timer, navigate to the Settings>Service menu and select Reset Lamp Hours. See page 33 for details.
squeeze lamp connector
loosen screw
Service menu
36
