SET UP Menu

The SET UP Menu allows you to adjust the picture for each input source separately: RGB1, RGB2, and VIDEO (Composite Video or S-Video).

NOTE: Before using the SET UP Menu, use the INPUT Menu to select one of the input sources, then repeat these steps for each of the other input sources (see next page). Two computers can be connected (using RGB1 and RGB2), and one video source should be be connected (using either the Composite video or S-video input port.) See page 5 for information about the input ports.

SET UP Menu Options

Adjustments

 

 

VOLUME

Decrease -- Increase

 

 

BRIGHT (BRIGHTNESS)

Darker -- Brighter

 

 

CONTRAST

Lower -- Higher

 

 

For VIDEO signal input only

 

 

SHARPNESS

Softer -- Sharper

 

 

COLOR (SATURATION)

Lower -- Higher

 

 

TINT

Red -- Green

 

 

For RGB signal input only

 

 

V POSIT

Moves picture up or down

(VERTICAL POSITION)

(or use automatic control)

 

 

H POSIT

Moves picture left or right

(HORIZONTAL POSITION)

(or use automatic control)

 

 

H PHASE

Decreases flicker/picture rolling

(HORIZONTAL PHASE)

(or use automatic control)

 

 

H SIZE

Widens/narrows horizontal size of

(HORIZONTAL SIZE)

picture (or use automatic control)

 

 

COLOR BAL

Red -- Blue

(COLOR BALANCE)

 

 

 

NOTE:

•TINT cannot be adjusted with PAL/SECAM video signal input.

•TINT, COLOR, and SHARPNESS cannot be adjusted with RGB signal nput.

•V. POSIT, H. POSIT, H. PHASE, and H. SIZE cannot be adjusted with VIDEO signal input.

VIDEO signal input

RGB signal input

How to use the SET UP menu

Use the MENU buttons on the projector (or DISK PAD on the Remote Control Unit) to move the cursor to the item you want to adjust.

For bar display items (VOLUME, BRIGHTNESS, CONTRAST, COLOR BALANCE) you must make adjustments manually using the on-screen controls (see illustration to the right).

For numerical display items (V POSIT, H POSIT, H PHASE, H SIZE) you have the option making adjustements manually or selecting AUTO (see illustration to the right). During automatic adjustment, the word "AUTO" will flash in the lower right corner of the screen; when the adjustment is complete, AUTO will disappear. This may take several seconds to complete.

bar display items

numerical display items

AUTO option (only applies to numerical display items shown above)

ViewSonic PJL855

Operation

 

9