Approach Tech NVR-2018 manual Set the regular record settings, Set the Alarm record settings

Set the regular record settings

1.When in the single –device mode, click to enter the SETUP page. (See the sample screen as in A above)

2.Select a desired recording rate and Quality from the corresponding drop-down list

3.At the left of the page are itemized Lancam 1() to 8() (See the sample screen as in C above), each of which is connected to the corresponding camera. So, if you click any of them, the corresponding camera’s information will appear in the blank spaces of all the items on the screen.

4.Adjust the LANCAM setup, including all the items on the screen given below:

Title

Connect LanCam

Motion (See the sample screen as in D above)

The information in all the above items’ attached spaces can be sent to the NVR.

5. Click the OK tag to proceed.

Set the Alarm record settings

1.When in the single –device mode, click to enter the SETUP page. (See the sample screen as in A above)

2.Set the ALRM SETTING to ON to enable the drop-down list in the ALARM SETTING area.

3.Select a desired recording rate and Quality from the corresponding drop-down list.

4.Click the OK tag to proceed.

Set the Record Schedule

1.When in the single –device mode, click to enter the SETUP page. (See the sample screen as in B above)

2.Set the Record Schedule to ON to enable the Record Schedule setting area.

3.Click the Time-Periodbutton to set the schedule for recording for each day. Go to both the START TIME

&END TIME boxes, enter a specific Hour: Minute and click Add button to add to the Record List.

4.When all required settings are completed, click OK to proceed.

65