APW Wyott FT1000H Troubleshooting Chart, The Problem, The Cause, The Solution

TROUBLESHOOTING CHART:

THE PROBLEM	THE CAUSE		THE SOLUTION
Won't toast...	a. Toaster cold.		a.	Allow five (5) minutes for warm up.
	b. Wrong power switch position.		b.	Position power switch to full power.
	c. Wrong conveyor speed setting.		c.	Reduce conveyor speed.
Toasts unevenly...	d. Only part of product surface is		d.	Reduce conveyor speed.
		Toasted.
	e. Product located too far to side of		e.	Place product on conveyor between
		conveyor.		end links.
Product sticks to	f. Butter or butter substitute used on		f.	Discontinue use of butter or butter
conveyor or slide..		product.		substitute.
	g. Conveyor surface has baked-on oil		g.	Follow daily cleaning methods to
		residue.		remove & prevent residue.
	h. Very moist or doughy product.		h.	Use different source or day-old
				product.
	i.	Product not defrosted or thawed.	i.	Defrost/thaw product.
No power...	j.	No power to receptacle.	j.	Check circuit breaker.
	k. Toaster unplugged.		k.	Plug in toaster.
	I. Loose connections.		I.	Check connections.
	m. Power switch.		m. Check that switch is on &
				operational.
Won't heat...	n. Loose connections.		n.	Check connections.
	o. Faulty power switch.		o.	Replace power switch.
	p. Burnt out element.		p.	Replace element.
Lighter toast	q. Speed control setting.			q. Reduce speed control setting.
Under peak loads.	r. Very moist product.		r.	Use different source or day old
				product.
	s. Product too cold.		s.	Allow product to warm to room
				temperature.
	t. Toaster cavity temperature being		t.	Add 1" or more spacing between
		quenched.		product.
Conveyor won't	u. No power.		u.	Check circuit breaker.
move...	v. Conveyor links are binding.		v.	Check conveyor for bent links.
	w. Drive chain too loose or too		w.	Adjust drive chain.
		tight.
	x. Loose or bad connection		x.	Check for loose or bad
		between speed control and		connection.
		conveyor motor.
	y. Conveyor motor burnt out.		y.	Replace conveyor motor.
	z. Speed control burnt out.		z.	Replace speed control.

7