APW Wyott FT 800H Warranty Procedure, Troubleshooting, Ii. Periodic Cleaning

D.Slide the reflector/crumb tray out of the toaster by pulling forward. Dispose of crumbs and wash the tray in hot, soapy water. Dry the tray and place it back into the toaster.

E.Remove the bottom toast drawer from the toaster by sliding it out and lifting up. Dispose of crumbs and wash the drawer in hot, soapy water. Wipe crumbs from inside the toaster with a hot, damp cloth. Dry the drawer and place it back into the toaster.

F.Wipe the exterior surfaces of the toaster with a hot, damp cloth.

II. PERIODIC CLEANING

A.Conveyor Belt

1.Remove the conveyor belt from the toaster.

2.Use needle-nose pliers to bend a link to the inside until the hook clears the link above.

3.Repeat on the other side.

4.Pull the loosened links together and slide through the center-of-belt link.

5.Clean the belt thoroughly (See item 2 under "daily cleaning").

6.Install the conveyor belt by reversing the order of steps noted above (See item 1).

NOTE: DO NOT INSTALL BELT BACKWARDS OR UPSIDE DOWN. ALIGN LINKS ACROSS SHAFT SPROCKET TEETH.

B.Cooling Intake Fan

1.Unplug and lay the toaster on its side.

2.Brush dirt and debris from the fan opening and fan guard.

3.WARNING: Neglecting to keep the fan-opening clean could result in toaster failure.

WARRANTY PROCEDURE

If warranty service is needed on your FASTRACTM, follow these steps:

I.Identify the model and serial number from the rating label on your toaster.

II.Consult the enclosed directory, find the service agency nearest you, call the number listed or the 24- hour toll free service hot line, 1-800-733-2203. If there is not a service agency listed for your area,

the parts distributor will provide service for your toaster.

III.To order parts consult the enclosed directory. The parts distributor is listed at the beginning of each state listing. The parts distributors have a complete stock of parts for your toaster.

TROUBLESHOOTING

I.Always ask and check the following:

A.Is the unit connected to a live power source?

B.Check the circuit breaker.

C.Is power switch on?

D.Is the unit operating on proper voltage? (see rating label)

E.Is power cord damaged? If YES, replace ONLY with an IDENTICAL power cord.

II.If problems exist after checking the above, check the chart below.

III.If any service is needed (italicized items), call an APW Wyott authorized service agency. All service should be performed by an APW Wyott authorized service agency.

6