APW Wyott M95-2-JIB operating instructions Location, Replace top and bottom control panels

ControlTop	FIGUREM951 -2-JIBASSEMBLYFeed	JamCONVEYORHEIGHTJAMScrewNutTONUTADJUST&SCREW
1 ConveyorAssemblyCBttomPanelontrol	MainPowerConvHangerSwitchyor	FIGURE 2
		2

a.To adjust the conveyor up into the drive gear, turn the conveyor adjustment screw clockwise. Use a 7/16-end wrench to tighten the jam nut.

b.To adjust the conveyor away from the drive gear, turn the conveyor adjustment screw counterclockwise. Use a 7/16-end wrench to tighten the jam nut.

5.Replace top and bottom control panels.

5. LOCATION

Place the toaster on a flat surface. Locate the toaster near a wall receptacle of the proper configuration. DO NOT USE AN EXTENSION CORD. Plug the power cord into an outlet (receptacle) of the specified voltage on the rating label. Outlets must be properly grounded.

6. OPERATING INSTRUCTIONS

1. Wet operation. (using oil) Season the toaster grill by applying a light coating of oil to entire grill surface (Fry oil can be used). When toasting using oil, any high-quality cooking oil may be used with this toaster (do not use oils that contain dairy products such as butter). Allow the griddle to heat up for 20 minutes. After 20 minutes season the grill surface again by applying another coating of oil to the entire grill surface. Fill the Butter Pan 2/3 full6of warmed cooking oil. The oil should spread evenly over the surface of the roller.

a. Turn Main Power Switch on. Set Temperature Control knob to 450 degrees Fahrenheit. Allow Pilot Light to cycle at least two times (on/off). When the light is on, the grill is heating. Heat up time is about 15-20 minutes.

b. Turn on motor switch. Conveyor should start to turn.

c. Holding the bun half in the palm of the hand, slap the face (cut side) of the bun on the turning Butter Roller surface.

d. Place bun halves on feeder cut side down (facing grill surface). Try several buns to determine the correct pressure and time to achieve the desired browning and temperature of bun. Using too little oil will cause the bun surface to be cool and uneven in color. It will also cause the bun to stick to the grill. Using too much oil will give the bun a yellow un-toasted look. Toast time is approximately 150 seconds depending on bun height and diameter. Increase or decrease the temperature setting to achieve desired brownness and temperature.

NOTE: Should the temperature setting be changed, allow several cycles for the grill plate to adjust. Once the desired setting has been achieved, note the temperature and keep it set there.