INSTALLATION

Low voltage wiring

Connecting the SuperCell Cable

1.The SuperCell cable connector is keyed and must be aligned to connect properly. Line up the cell cord and plug into the cell cord connector, located on the bottom right of the Pool Pilot Digital base plate.

2.The other end of the SuperCell cable may have a red weather plug located in one of the holes. The SuperCell will have either 2 or 3 electrical terminals

•If the SuperCell has 3 electrical contact terminals then the red weather plug should be removed and discarded.

•Align the cable and terminals and connect them together.

•If the SuperCell has 2 electrical contact terminals, then the red weather plug will seal the unused contact in the cable. Position the SuperCell plug so that the two open holes align with the two mating terminals and connect them together.

Connecting the Tri-Sensor Cable

The Tri-Sensor Cable is 12 feet (3.4m) long and connects the Tri-Sensor Assembly to the

Pool Pilot Digital. Both ends are keyed and must be aligned to connect properly.

•Connect the white 6-pin connector to the mating plug located on the base of the Pool Pilot Digital.

•Remove the black dust cap that covers the electrical connector on the Tri-Sensor Assembly located near the top of the Manifold Assembly.

•Carefully align the black 6-pin connector to the mating plug

located on the Tri-Sensor Assembly. The cable

 

 

connector has a slot that will align with the slot on the

 

 

mating plug. (The slot on the plug is aligned with the

 

 

Tri-Sensor Directional Flow Indicator.) Do NOT force!

 

 

• Carefully slide the connector into the mating plug.

 

Tri-sensor

Twist the cable connector locking-ring to secure the

 

 

assembly

connector to the Tri-Sensor.

 

 

connector

 

 

 

Ground Lug

Cell Cord Connector

 

Digital Control Panel Base Plate

Tri-Sensor

Tri-Sensor

 

 

Cable

SuperCell

 

Cable

Directional Flow

Cable

 

 

 

Indicator

 

 

Dust

Cap

Plug key

!Warning The pins in the Tri-Sensor plug will be permanently damaged, requiring Tri-Sensor replacement, if the connector is forced on or not aligned properly during insertion. DO NOT FORCE!

15

A T O L I P O TS M E T S Y SI