INSTALLATION
Mounting the Pool Chemistry Controller Unit
Caution: All electrical connections should be made by a licensed electrician or certified electrical contractor.
Your Pool Chemistry Controller is suitable for indoor or outdoor mounting. The cover of the Pool Chemistry Controller is removed from the sides by four thumbscrews so it is advisable to leave adequate space on the sides for hand access to the thumbscrews.
Read the following section completely before proceeding:
1.Level and tape the mounting template to the selected mounting location. Mark the wall for the 4 mounting holes.
2.Plastic anchors and screws have been provided for concrete or stucco walls. Drill and install the plastic anchors and/or screws. Leave a ¼” gap from the wall when tightening the screws.
3.Loosen but do not remove the 4 thumbscrews on the sides of the Control Unit.
(2 thumbscrews on each side)
4. Carefully slide off the outer housing cover.
5.Safely set the cover aside.
6.Hang the Pool Chemistry Controller unit on the four mounting screws.
Using a long shaft slotted screwdriver, tighten the screws through
the black plastic access holes (indicated by | ). |
18