Arcam AVP700 manual IR Remote Codes, Command Command code

IR Remote Codes

The following information is supplied for owners of advanced programmable remote controls, such as the Philips ‘Pronto’ and similar devices, where it is possible to program remote codes directly into the device.

The coding system for the AVP700 is based on the Philips RC-5 standard. The main system control uses RC-5 system codes ‘16’, with the tuner section using system code ‘17’ (this is to provide compatability with existing ARCAM tuners). So, for example, to program in a ‘Stand-by’ command, use the command ‘16-124’.

Zone 2 also uses RC-5 system code 16 as standard, as Zone 2 is normally operated in a separate room using a standard (system code 16) remote control.

Main system control code, system code 16. Items shown in THIS STYLE indicate the equivalent remote control button of the supplied CR-80 remote control.

Command	Command code
Stand-by	124
On	123
Zone 1 stand-by	125
Power toggle	12
Display (DIS)	59
Menu (MENU)	82
Info	55
Mute	119
Un-mute	120
Mute toggle (MUTE)	13
Volume up	16
Volume down	17
SAT input	0
AV input	2
TUNER input	3
DVD input	4
TAPE input	5
VCR input	6
AUX input	8
CD input	7
DVD-A input	9
Stereo Direct on	78
Stereo Direct off	79
Stereo Direct toggle	10
Up	86
Down	85
Left	81
Right	80
OK	87

Command	Command code
MODE	32
Mono mode	106
Stereo mode	107
Dolby PLII Movie	108
Dolby PLII Music	109
(Reserved)	102
Dolby PL Emulation	110
DTS Neo:6 Cinema	111
DTS Neo:6 Music	112
Dolby PLIIx Movie	103
Dolby PLIIx Music	104
(Reserved)	105
Effect (FX)	70
Effect off	63
Effect: Music	64
Effect: Party	65
Effect: Club	66
Effect: Hall	67
Effect: Sport	68
Effect: Church	69
Trim menu (TRM)	37
Sub trim menu (SUB)	51
Lip sync. (SYN)	50
Setup menu (SETUP)	84
Satellite video	19
AV video	20
DVD video	22
Tape video	23
VCR video	24
Video standard	126

Zone 2 on from Zone 1	47
Zone 2 off from Zone 1	48

Preset/Tune down (P-)	57
Preset/Tune up (P+)	56
Preset/Tune mode toggle	54

AVP700

E-30