Arcam BDP300 Specifications, Radio interference, Laser radiation, Continual improvement policy

specifications

Analogue Audio Output

Digital to Analogue conversion	24-bit 192kHz Delta-Sigma DAC
Signal to noise ratio	110dB CCIR
Harmonic distortion (1kHz)	0.002%
Frequency response (±0.5dB)	10Hz–20kHz
Output level (0dB)	2.2Vrms
Output impedance	47Ω
Minimum recommended load	5kΩ
Video Outputs
Composite video	1 x phono. 1V pk-pk in 75Ω
Component video	Interlaced or Progressive
	3 phono sockets.
	Y 1V pk-pk in 75Ω, Pb 0.7V pk-pk in 75Ω, Pr 0.7V pk-pk in 75Ω
HDMI	19-pin HDMI connector
	Supported video formats are:
	720 x 576p, 720(1440) x 576i, 720 x 480p, 720(1440) x 480i,
	1280 x 720p, 1920 x 1080i, 1920 x 1080p
	Audio to 8-channel/96kHz or 2-channel/192kHz (24-bit).
Digital interfaces
USB	USB 2.0 High Speed (480 Mbit/s)
Network	10 BASE-T / 100 BASE-TX
Physical
Dimensions	W433 x D400 x H100mm
Weight	6.2kg nett/8.5kg packed
Power consumption	17W maximum
Digital output connection	75Ω co-axial
	optical TOSLINK
Supplied accessories
	Mains lead
	CR104 remote control
	4 x AAA batteries
E&OE

NOTE: All specification values are typical unless otherwise stated

Radio interference

The BDP300 Blu-ray Disc player is a digital device which has been designed to very high standards of electromagnetic compatibility.

All Blu-ray players generate, and can radiate RF (radio frequency) energy. In some cases this can cause interference with FM and AM radio reception. If this is the case, keep the player and its connecting cables as far from the tuner and its aerials as possible. Connecting the player and the tuner to different mains sockets can also help to reduce interference.

EC COUNTRIES – This products have been designed to comply with EMC Directive 2004/108/EC.

USA – These products comply with FCC Part 15 Class B.

Laser radiation

If the BDP300 Blu-ray Disc

CLASS II player is operated whilst

LASER PRODUCT

the outer casing is removed, invisible laser radiation could cause eye damage.

Continual improvement policy

Arcam has a policy of continual improvement for its products. This means that designs and specifications are subject to change without notice.

E-30