to stop shooting. Then the photos can be downloaded one by one.
2.The camera will regain previous status after shooting and releasing of shutter button.
Note: Under the continuous shooting mode, the shooting may fail due to poor lighting.
Deleting All Photos
1.Upon starting of camera, press delete function button for two times and select the “
” icon shown on the LCD display.
2.Pressing the shutter button again within 5 seconds will delete all the photos stored in the memory. Then this function will be eliminated.
Deleting Single Photo
1.Upon starting of camera, press delete function button for one time and select the “
” icon shown on the LCD display.
2.Press the shutter button within 5 seconds once to delete the last photo taken.This function will be eliminated later.
Flash
Upon starting of camera, move Flash Slide Switch to the end with flash sign and the flash will being charging. About 6 seconds later, LED will be on, which means fully charging. Press shutter button, Photo will be taken with flash Then LED will be out. About 6 seconds later, LED will be on (the charging time will be different with battery capacity) again for shooting. (Under flash mode, press the shutter button only after full charging in order to avoid chip failure.)
The camera cannot take photo if the ambient light is totally insufficient Note: To make sure the quality of photo, it’s highly recommended to use the flash indoors and at night. The best effective flash distance is within1.5M.
-9 -
