4

6

5

Tighten existing tapping screw.

Figure 6

CAUTION: Exhaust gases can melt mesh bags and cause a fire hazard. Make sure the exhaust gases vent away from the mesh bags.

7.Connect the lower heat deflector to the bagger mount weldment (item 4) with the hardware removed in step 2. See Figure 7.

8.Install the heat deflection shield (item 8) on the bagger mount weldment (item 4) with two 3/8-16 x 1/2 tapping screws (item 7). See Figure 7.

Connect existing lower heat shield to bagger mount with hardware removed in step 2.

7

8

Figure 7

9.Install the bagger cover assembly (item 9) on the bagger mount weldment (item 4) with two

9/16 x 1-3/8 flat steel washers (item 13) and two 5/16-18 clamping knobs (item 14). Keep them loose until the bagger supports are installed. See Figure 8.

10.Install the right bagger support weldment (item 11) and the left bagger support weldment (item 10) on the right and left side cover assembly. Secure the supports to the cover assembly with a hair pin, #25 (item 24) and to the unit frame with a 3/8-16 x 1 hex bolt (item 5) and 3/8-16 center lock

nut (item 12). Keep hardware loose until both straps are installed, and then tighten all hardware.

NOTE: The left and right supports are different. Make sure they are oriented properly before installation. Install the right support first.

11