OPERATION

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

Before Each Use

1.Check bagger parts for wear, deterioration or damage. Replace ONLY with original manufacturer service parts before operating.

2.Make sure counterweights are installed.

3.Make sure all hardware is tight.

IMPORTANT: Check tool-less hardware often. Tighten as needed.

4.Remove any grass buildup from bagger parts.

5.Make sure hose is fastened securely on upper boot and blower assembly.

6.Make sure mesh bags are installed, and the bagger cover is closed and securely latched.

Bagging

WARNING: Do not operate on slopes over 10°

DO NOT operate mower unless guards are in place or blower assembly and entire bagger are attached.

Starting

1.Start engine and engage PTO according to unit owner’s manual.

2.Set throttle to full.

3.Choose a slow ground speed.

Shut Off

1.Disengage PTO.

2.Shut off unit according to unit Owner/Operator’s manual.

WARNING: Lower attachment, stop engine, and remove key to prevent unauthorized use. DO NOT park on slopes.

Emptying mesh Bags

If bagger stops picking up grass clippings, mesh bags may be full.

To empty bags:

1.Disengage PTO, stop engine and remove ignition key. Wait for all moving parts to stop before leaving operator’s position.

2.Empty the grass from each bag.

3.Clean out hose.

4.Close and latch cover.

Unclogging Bagger

WARNING: MOVING PARTS can cut or amputate body parts.

NEVER attempt to clear blower assembly while engine is running.

ALWAYS stop engine, remove key, and wait for moving parts to stop.

Sharp edges can cut. Movement of parts can cut off fingers or a hand. Wrap blade(s), wear sturdy gloves and use extreme caution when working near blades or impeller.

r

WARNING: PINCH POINT! Use extreme caution when unclogging blower assembly. Impeller can cut or pinch your hand, even when not in operation. Wear sturdy gloves when working near impeller.

If hose or blower assembly gets clogged, stop forward motion and allow unit to clear itself. If unit will not clear itself, unclog the hose and/or blower assembly manually as instructed below.

1.Stop engine and remove ignition key. Wait for all moving parts to stop.

2.Lift thumb latch on bagger assembly and remove hose (figure 14).

3.Remove hose from blower assembly.

NOTE: Perform steps 4 and 5 if clog is in the hose:

4.Remove clogged grass.

5.Reinstall hose.

NOTE: Perform steps 6 and 7 if clog is in blower assembly.

WARNING: Blades rotate when impeller rotates. Impeller rotates when blades rotate. Block blades to prevent rotation before proceeding.

6.Clear grass from blower assembly.

7.Reinstall hose and close the thumb latch.

Operating Tips

•Cut grass when it is dry.

•Cut grass in two passes when cutting thick, long, or wet grass. Make the first cut higher than desired. Make the second cut at desired height.

•Always use full throttle when bagging.

16