2.Connect the wheel drive cable spring to the idler arm as shown in Figure 20, and then connect the wheel drive cable to the transmission mount. See Figure 17.
Figure 20
3.Connect the idler return spring to the idler arm.
4.Install the blade adapter and blade on the crankshaft. Make sure the blade hardware is tightened to the proper torque. See To install blade: on page 17.
5.Replace the transmission cover.
6.Connect spark plug wire to the spark plug.
ENGINE/BLADE CONTROL ADJUSTMENT
NOTE: The engine/blade control has no user serviceable adjustments. If the engine/blade control does not stop the engine or blade within 3 seconds of releasing the control bail, take the unit to an authorized Ariens dealer for repairs.
BATTERY (electric start models)
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before proceeding.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.
NOTE: Unit comes equipped with a
To Remove Battery from Unit
1.Disconnect negative
2.Remove battery cover and battery. Save mounting hardware for reinstallation.
To Replace Battery on Unit
1.Hold battery and battery cover in place against mower frame.
2.Secure with the hardware removed above.
3.Connect negative
Figure 21
To Charge Battery
NOTE: Engine does not charge the battery. Battery will require periodic charging to ensure proper starting.
IMPORTANT: DO NOT attempt to “jump start” mower.
IMPORTANT: DO NOT start engine while the charger is connected to wiring harness.
1.Connect battery charger to the wiring harness. See Figure 22.
2.Plug charger into 110 volt Alternating Current (A.C.) outlet.
IMPORTANT: Battery charger supplied with unit is for 110 volt Alternating Current (A.C.) outlets only.
3.Charge for 24 to 48 hours (battery may be charged for up to 52 hours without damaging it).
GB - 21