Manual Start

1.Check each item in the Before Each Use section of the MAINTENANCE SCHEDULE on page 17.

2.Open fuel shutoff valve (911112, 113).

3.For engines with a primer, push primer bulb 2 or 3 times for a cold engine.

NOTE: It is unnecessary to prime or choke a warm engine.

4.For engines with a throttle, place throttle control in the choke position. Once the engine has started, place throttle in the high speed detent.

5.With engine/blade control held against the handlebar, grasp starter handle and pull rope slowly until it pulls harder. This is the compression stroke. Let rope rewind slowly.

6.Pull rope with rapid continuous full arm stroke to start engine. Allow rope to rewind slowly.

IMPORTANT: DO NOT let starter handle snap against bracket.

7.Repeat steps 4 and 6 until engine starts. (If engine does not start, see TROUBLESHOOTING on page 23.)

Electric Start (911113)

Recoil may also be used to start the engine (see Manual Start on page 16).

1.Check each item in the Before Each Use section of the MAINTENANCE SCHEDULE on page 17.

2.For engines with a primer, push primer bulb 2 or 3 times for a cold engine.

NOTE: It is unnecessary to prime or choke a warm engine.

3.With engine/blade control held against the handlebar, turn the key to “Start” position to crank engine and release key when engine starts.

IMPORTANT: Do not run starter continuously for more than fifteen seconds. If the engine does not start after several attempts, refer to TROUBLESHOOTING on page 23.

Shut Off

1.Release wheel drive control and allow unit to stop completely (self-propelled models).

2.Release engine/blade control.

3.Turn key to off position and then remove key (electric start models).

Mowing Tips

Cut grass when it is dry. Keep mower blades sharp.

Do not set cutting height too low. For tall grass, mow twice.

Do not mow too fast.

Mow with engine at full throttle. Discharge clippings into areas already cut.

Vary cutting pattern with each mowing.

NOTE: To prevent dirt and grass from collecting on mower pan, avoid operating over bare ground with only patches of grass.

Mulching Tips

For best mulching performance, cut no more than 1 inch (2.54 cm) of grass per cutting.

GB - 16