6.Connect the engine/blade control cable to the engine.

Route the z-bend cable end into engine shutoff lever as shown below.

Insert the cable connector into the cable mounting bracket on the engine. Make sure the connector snaps into place securely.

911110, 111

911112, 113

Figure 5

7.Fill engine crankcase with oil. See engine manual.

8.Set-up mower for bagging, side discharge or mulching. See MOWER SET-UPon page 14.

NOTE: Bagging is not standard on push models. See ACCESSORIES on page 24 for kit part numbers.

9.Fill fuel tank. See FILLING THE FUEL TANK on page 13.

10.Connect the battery. See BATTERY (electric start models) on page 21.

11.Connect spark plug wire.

12.Check the engine/blade control feature. Try starting the engine without the engine/blade control held against the handlebar. Engine must not start. If engine starts, stop engine and bring the unit to your dealer for adjustment or repair.

GB - 9