911112, 113

To drive forward:

Slowly pull the wheel drive control toward you until you reach a comfortable ground speed. Hold the wheel drive control in this position to maintain the speed.

To stop:

Release wheel drive control.

Figure 9

Speed Control Knob (91112, 113)

The speed control knob stops the wheel drive control’s travel which limits the unit’s maximum forward speed.

Turn the speed control knob counterclockwise to increase the unit’s maximum forward speed. Turn the speed control knob clockwise to decrease the unit’s maximum forward speed.

Figure 10

Fuel Shutoff Valve (91112, 113)

IMPORTANT: The fuel shutoff valve MUST be in the closed position prior to transporting the unit.

Open the fuel shutoff valve to operate the unit. Close the fuel shutoff valve when storing, transporting or servicing the unit.

Fuel shutoff valve open.

Fuel shutoff valve closed.

Choke Control (91112, 113)

Move choke lever to the choke position to start a cold engine.

NOTE: The choke will slowly open as the engine warms.

Ignition Switch (911113)

A removable key

1operates the ignition switch. Turn the key to the start position (2) to start the unit. The key

2will spring back to the “RUN” position.

RUN Position (1): All controls are operable.

START Position (2): Starter turns over the engine.

FILLING THE FUEL TANK

To add fuel to fuel tank:

1.Put unit in open or well-ventilated area.

2.Stop engine and allow to cool.

3.Clean fuel cap and surrounding area.

4.Remove cap.

IMPORTANT: See engine manual for correct type and grade of fuel.

5.Fill fuel tank to within 1/4 in. (0.63 cm) below bottom of filler neck with unleaded gasoline. See SPECIFICATIONS on page 25.

6.Replace fuel cap and tighten.

7.ALWAYS clean any spilled fuel.

GB - 13