CHECK WHEEL DRIVE CONTROL
The unit must stop quickly and completely when the control is released. Adjust or repair
if necessary. See WHEEL DRIVE CONTROL ADJUSTMENT on page 22.
CHECK GRASS BAG
Check grass bag frequently for wear or deterioration. Replace worn or damaged bag with an Ariens original equipment replacement bag only.
CLEAN UNIT
Before each use clean unit, muffler and engine surfaces of debris, oil or fuel spills to ensure proper cooling and prevent fires.
CHECK ENGINE OIL
IMPORTANT: Maintain proper oil level at all times or engine damage will result.
Check the level of the engine crankcase oil before each use.
Make sure engine is level when checking oil. See engine manual for instructions.
CHECK MOWER BLADE
See Figure 11.
Check blade mounting: blade must be secure and bolt torqued to 37.5 – 50
68 N•m) (bolt should fully compress lock washer).Check blade for nicks and dull cutting edges. Sharpen if necessary.
Check blade for rounded or broken ends, thinned metal or other damage. Replace if necessary.
NOTE: Blades should be sharpened and balanced professionally. Contact your Ariens Dealer.
To remove blade:
1.Stop engine, wait for all moving parts to stop, and disconnect spark plug wire.
2.Block blade to prevent rotation.
3.Remove bolt, lock washer, flat washer and blade from shaft.
To install blade:
1.Replace blade, flat washer, lock washer and bolt on shaft.
2.Torque bolt to 37.5 – 50
68 N•m) (bolt should fully compress lock washer).
3.Connect spark plug wire.
Sharpen the Mower Blades
CAUTION: DO NOT sharpen mower blades while on unit. An imbalanced mower blade will cause excessive vibration and eventual damage to unit. Check mower blade balance before reinstalling blades.
NEVER weld or straighten bent blades.
1.Remove mower blade from unit. Discard mower blade if:
•More than 1/2 in. (1.27 cm) of metal is removed.Air lifts become eroded.
•Blade is bent or broken.
2.Sharpen mower blade by removing an equal amount of material from each end of mower blade. DO NOT change angle of cutting edge or round the corner of the mower blade.
DO NOT Sharpen to This Pattern |
| |
1 | 2 |
|
3 |
|
|
DISCARD If More Than |
| |
1/2 in. (1.27 cm) | 2 | |
4 | 3 | OT0792 |
| ||
Sharpen to This Pattern |
| |
1. | Square Corner |
|
2. | Cutting Edge |
|
3. | Air Lift |
|
4. | Air Lift Erosion |
|
| Figure 11 |
|
GB - 18