REPLACING HYDROSTATIC BELT

Remove (Figure 22)

 

1

 

2

 

 

 

3

 

 

 

4

2

8

 

 

 

 

 

 

7

 

5

 

6

 

1.

Hydrostatic Belt

4.

Pulley

2.

Hydrostatic

5.

Clutch Stop

 

Transmission

6.

Electric Clutch

 

Pulley

7.

Idler

3.

Electric Clutch

8.

Idler Spring

 

Connector

 

 

Figure 22

OE0051

 

1.Remove PTO belt (see REPLACING PTO BELT on page 24).

2.Disconnect electric clutch connector.

3.Remove clutch stop.

CAUTION: Use care when releasing idler spring tension. Keep body parts well away from idler when performing this operation.

4.Disconnect idler spring.

5.Remove hydrostatic belt from hydrostatic transmission pulleys, pulley, electric clutch, and idler.

Install (Figure 22)

1.Install hydrostatic belt on idler, electric clutch, pulley, and hydrostatic transmission pulleys.

2.Connect idler spring.

3.Install clutch stop.

4.Connect electric clutch connector.

5.Install PTO belt (see REPLACING PTO BELT on page 24).

STORAGE

Short Term Storage

IMPORTANT: NEVER clean unit with high-pressure water or store unit outdoors.

Remove all dirt, grease, leaves, etc. Store in a clean dry area.

Inspect unit for signs of wear or damage. Ensure all fasteners are properly tightened.

Long Term Storage

Follow all instructions under Short Term Storage.

Remove and fully charge battery. Store in a clean dry area.

Drain fuel from fuel tank.

Refer to Engine Manual for the proper engine storage procedures.

Touch up all scratched or chipped paint surfaces.

GB - 25