MAINTENANCE
Ariens dealers will provide any service or adjustments which may be required to keep your unit operating at peak efficiency. Should engine service be required, contact an Ariens dealer or an authorized engine manufacturer's service center.
WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.
SERVICE POSITION
WARNING: Before tipping unit up onto housing, remove fuel so no spills will occur. Ensure unit is secure and will not tip over during maintenance.
Place unit on a flat level surface. Tip unit forward onto front of auger housing for service. Ensure unit is secure and will not tip over. Strap and clamp onto bench if needed.
Service Position
Figure 10 | OS8240 |
MAINTENANCE SCHEDULE
The chart below shows the recommended maintenance schedule that should be performed on a regular basis. More frequent service may be required.
MAINTENANCE SCHEDULE
Service | Each | Every | Every | Yearly |
Performed | Use | 5 hrs. | 25 hrs. |
|
Check Dual | • |
|
|
|
Handle |
|
|
|
|
Interlock |
|
|
|
|
Check | • |
|
|
|
Fasteners |
|
|
|
|
Check Clutch | • |
|
|
|
Operation |
|
|
|
|
Check Clutch |
| * | • |
|
Spring |
|
|
|
|
Adjustments |
|
|
|
|
Clean Engine | • |
|
|
|
Check Engine |
| • |
|
|
Oil |
|
|
|
|
Change |
| ** | • |
|
Engine Oil |
|
|
|
|
Check Tire |
|
| • |
|
Pressure |
|
|
|
|
Check Auger |
|
| • | • |
Gearcase |
|
|
|
|
General |
|
| • | • |
Lubrication |
|
|
|
|
*After first five hours of operation.
**After first two hours of operation.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
GB - 17