921005
Discharge Chute
Adjusting Deflector
Hardware
Discharge
Chute
SPEED SELECTOR
ADJUSTMENT
To adjust (Figure 32):
1. | Disconnect adjustment pivot pin from |
| speed selector lever by removing hair |
| pin. |
2. | Place the speed selector on the dash in |
| the fastest forward speed position. |
3. | Turn the speed selector lever straight |
| down towards the ground as far as it will |
| go. |
4. | Thread the adjustment pivot pin along |
| the shift rod until it aligns with the mating |
| hole on the speed selector lever. Insert |
| the pivot pin into hole. |
5. | Secure adjustment pivot pin with hairpin. |
6. | Make sure the speed selector shifts into |
| each speed position. |
7. | Check forward and reverse speeds: |
| a. Start unit. |
| b. Shift speed selector into the first |
Figure 30
OS7176
forward speed. |
c. Engage the traction clutch. Unit |
should move forward. |
DISCHARGE CHUTE (921005)
If discharge chute does not stay in position while operating, tighten nut on carriage bolt at pivot point to increase tension on spring (Figure 31).
921005
1
2 
1
OS7177
1. Spring | 2 |
2.Nut Figure 31
d. Stop unit. |
e. Shift speed selector into first |
reverse speed. |
f. Engage the traction clutch. Unit |
should move backward. |
g. Shut off unit. |
8. Adjust pivot pin on the shift rod as |
necessary so unit travels forward when |
speed selector is in first forward position |
and travels backward when speed |
selector is in first reverse position. |
9. Connect the pivot pin to the speed |
selector arm with the hardware removed |
in step 1. |
14
3 | OS7186 |
2
1.Shift Rod
2.Adjustment Pivot Pin
3.Speed Selector Lever
4.Hairpin
Figure 32
GB - 27