Track Angle (921007, 008, 009)

(Figure 19)

The track angle can be adjusted to position the auger housing for level clearing, deep cutting or transport.

Squeeze the handlebar trigger and press down on the handlebars to move the auger housing into an up position. Release the trigger to hold the position.

Lift up on the handlebars and squeeze and release the handlebar trigger to move the auger housing into a down position.

Normal

Transport

Deep Cutting

Figure 19

OS7111

FILLING FUEL TANK

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

Fuel Shut-Off Valve

IMPORTANT: The fuel shut-off valve MUST be in the closed position prior to transporting the unit.

The fuel shut-off valve has two positions:

Closed Position: Use this position to service, transport, or store the unit.

OS7117

Open Position: Use this position to run the unit.

Figure 20

To add fuel to fuel tank:

1.ALWAYS place unit in open or well- ventilated area.

2.Stop engine and allow to cool.

3.Clean Fuel Cap and surrounding area to prevent dirt from entering Fuel Tank.

4.Remove Cap.

IMPORTANT: DO NOT use gasohol or gasoline containing alcohol. See Engine Manual for correct type and grade of fuel.

5.Fill fuel tank to within 1/2 in. (1.2 cm) below bottom of filler neck with unleaded gasoline.

NOTE: Tank capacity is 1 gallon (3.8 liters).

6.Replace Fuel Cap and tighten.

7.ALWAYS clean up any spilled fuel.

PRE-START

1. Frozen Impeller

IMPORTANT: Before starting engine, check impeller to be sure it is not frozen.

To check impeller:

1.With ignition key switch in “Stop” position, squeeze Attachment Clutch Lever to Engaged position.

2.Pull Recoil Starter Handle.

3.If Impeller is frozen, (cannot pull Starter Handle) move unit to a heated area and thaw to prevent possible damage.

GB - 19