921005

3

4

1 2

OS7061

1.Chute Rod

2.Gear Cover

3.Control Panel

4.Spring Pin Clip

Figure 10

4.Insert the short end of the chute rod into the hole in the front of the control panel.

5.Connect the chute crank to the pinion gear on chute with spring clip.

IMPORTANT: Rotate the discharge chute to the left when tightening the pedestal hardware to ensure clearance between the discharge chute and the belt cover.

6.Tighten pedestal hardware to 15 – 31 lbf-ft (20 – 42 N•m).

Deflector Remote (921004, 006, 007, 008, 009)

(Figure 11)

Connect the cable end to the cable anchor on the discharge deflector before clipping the cable to the cable bracket on the discharge chute.

1.Route deflector remote cable along the left side of the chute pedestal.

2.Insert the barrel on the cable end into the bracket on left side of chute deflector (Figure 11).

3.Hold seal out of the way while routing the cable through the bracket on the left side of the discharge chute, and then push the cable fitting into the bracket.

4.Push the seal securely over the end of the cable fitting to prevent water from entering the cable.

5.Check deflector travel. Adjust nut on cable end under handlebar to obtain full travel, if necessary. (see Deflector Remote (921004, 006, 007, 008, 009) on page 25).

23

1

3

5

4

1. Cable Anchor

OS7070

 

2.Cable End

3.Deflector Cable

4.Cable Fitting

5.Cable Bracket

Figure 11

Check Function of Dual Handle Interlock

Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If they do not, contact your Dealer for repairs.

Check Tire Pressure (921004, 005, 006)

Check tire pressure and adjust to the pressure listed on tire sidewall.

GB - 11