Ariens 932309 - 824, 932101 - 824 manual Scraper Blade, Shear Bolts, Runners, For Replacement

		SCRAPER BLADE
		IMPORTANT: Damage to auger/impeller
		housing will result if blade wears down too far.
		Scraper blade is adjustable to compensate for
1		wear.
		To adjust scraper blade:
2
		1. Tip unit back onto handlebar, support
3		housing and loosen nuts retaining blade.
4		2. Adjust runners to fully raised position
		(housing closest to ground).
1. Pinion	DS0113	3. Reposition scraper blade flush with
		runners and tighten lock nuts.
2. Chute Gear
		SHEAR BOLTS
3. Carriage Bolt
4. Spring		IMPORTANT: Use only Ariens shear bolts for
		replacement. Use of any other type of shear
Figure 10		bolt may result in severe damage to unit.
		Occasionally a foreign object may enter the
RUNNERS
		auger/impeller housing and jam the auger,
Runners should be adjusted (Figure 11) as		breaking shear bolts (Figure 12) which secure
		the auger to the shaft. This allows auger to
conditions require.
		turn freely on the shaft preventing damage to
1. Position unit on a hard, flat, smooth level
		gear drive.
surface.
		For Replacement:
2. Adjust runners by inserting a spacer of
		1. Slide auger outward against roll pin and
desired thickness under center of scraper
blade, loosen runner hardware, slide		align hole in shaft with hole in auger
runners to flat surface. Allow 1/8 in		(holes in shaft for roll pins and shear bolts
(3 mm) between scraper blade and hard		line up).
smooth surfaces. Allow 1-1/4 in (30 mm)		2. Drive shear bolt through hole (if shear bolt
between scraper blade and uneven or		was broken this will drive remaining part
gravel surfaces. Retighten hardware.		from shaft).
NOTE: Keep housing level by adjusting		3. Secure shear bolt with nut.
runners equally.

		3
2
1
1. Runner	1	OS0402
2. Runner Hardware
		2
Figure 11		1. Auger
		2. Shear Bolts
		3. Roll Pin
		Figure 12
	GB - 21