OPERATION
CONTROLS AND FEATURES
Auger Clutch Bail
Refer to Figure 1 on the inside front cover for controls and features locations.
Ignition Switch
The ignition switch is operated with a removable key that has two positions.
WARNING: ACCIDENTAL ENGINE START UP or UNAUTHORIZED USE could result in death or serious injury. ALWAYS shut off unit and remove key before servicing or leaving unit unattended.
Engaged |
Disengaged |
OS1560 |
Squeeze the auger clutch bail against the handlebar to engage auger.
Release bail to disengage and brake auger.
STOP | "STOP" Position: Ignition system is shut |
| down. |
| "RUN" Position: All controls are |
RUN | operable. |
| |
OS1680 |
|
To start the engine, the key must be in the "RUN" position.
To stop the engine, turn the key to the "STOP" position.
Auger
WARNING: THROWN OBJECTS could cause personal injury and/or property damage. ALWAYS discharge in a safe direction. Disengage auger when unit is traveling to work area or is not in use. Use extreme caution when operating on or crossing gravel surfaces.
CAUTION: STRIKING FOREIGN OBJECTS may damage unit and result in minor or moderate injury. Shut off unit and engine. Check for any damage or loose parts and repair before restart.
When handlebar is lifted so auger contacts the ground, auger propels unit forward while collecting snow. Forward speed will vary according to depth and moisture content.
WARNING: IMPROPER ADJUSTMENT could result in death or serious injury. AUGER BRAKE MUST DISENGAGE when clutch is engaged. BRAKE MUST STOP AUGER WITHIN 5 SECONDS of releasing auger clutch bail.
IMPORTANT: Check auger to be sure it is not frozen. If belt squeals when clutch bail is engaged, auger is frozen. Immediately release the clutch bail and move the unit to a heated area to thaw.
IMPORTANT: Check clutch/brake function before each use. If auger clutch bail moves freely with no resistance before contacting handlebar, adjust or repair unit before operating.
Primer Bulb
Push in the primer Bulb to add fuel for easier engine start. See Starting and Shut Off.
OS1620
Choke Control Knob
When pulled out (away from auger housing) the choke control knob chokes
off air to the engine for easier start. When pushed in, control knob allows for
OS1570 normal operation.
IMPORTANT: When engine has started, open choke slowly by gradually pushing choke control in.
Recoil Starter Handle
When pulled, handle will crank engine.
IMPORTANT: DO NOT let handle snap back against unit.
Discharge Chute
The discharge chute directs the flow of snow away from the area being cleared. The discharge chute rotates 220°. Rotate chute with the discharge chute handle.
DANGER: ROTATING PARTS will cause serious injury or death. NEVER reach into discharge chute or housing while engine is running.
GB - 9
