SERVICE AND ADJUSTMENTS
WARNING: ACCIDENTAL ENGINE START UP can cause death or serious injury. ALWAYS stop engine, remove key, and wait for moving parts to stop before performing maintenance or service.
HOT SURFACES can cause death or serious injury. DO NOT touch parts which are hot from operation. ALWAYS allow parts to cool.
CAUTION: FUEL SPILLS may result in minor or moderate injury and/or damage to unit. If unit must be tipped, remove enough fuel so that no spills will occur.
SERVICE POSITION
Place unit on a flat level surface.
TO ADJUST DISCHARGE CHUTE DEFLECTOR
If discharge chute deflector does not stay in set position during operation, adjust chute by tightening fasteners evenly until deflector stays in position.
Fasteners
OS0181
NOTE: Use a T30 Torx Drive or a 3/16” (.19 cm) wide Straight Screwdriver to tighten.
TO REPLACE THE DRIVE BELT
1.Remove fuel cap.
2.Remove cowl and replace fuel cap.
3.Disconnect extension spring on idler arm/brake.
4.Remove cap screw and washer from end of auger shaft and pull off auger drive pulley.
5.Remove old belt.
6.Install new belt onto pulleys
7.Reinstall auger drive pulley and secure with washer and cap screw
8.Reconnect extension spring to idler arm/brake.
9.Ensure belt finger(s) and auger clutch control cable are properly adjusted. See To Adjust Belt Finger and To Adjust Auger Control Cable.
10.Remove fuel cap and replace cowl.
11.Replace fuel cap.
|
|
|
|
| |
|
|
|
| 4 | |
| 1 | 2 | 3 | 6 | |
|
|
| 5 | ||
|
|
|
| ||
|
|
|
|
| 7 |
|
|
|
|
| 5 (3HP) |
9 |
|
| 8 |
|
|
|
|
|
|
| |
1. | Extension Spring |
|
| ||
2. | Idler Arm/Brake |
|
| ||
3. | Idler |
|
|
|
|
4. | Slot |
|
|
|
|
5. | Belt Fingers |
|
| ||
6. | Auger Clutch |
|
| ||
| Control Cable |
|
| ||
7. | Drive Belt |
|
|
| |
8. | Auger Drive Pulley |
|
| ||
9. | Cap Screw, Washer, Auger Shaft | ||||
|
|
|
|
| OS0053 |
TO ADJUST BELT FINGER
3HP units have two belt fingers.
5HP units have one belt finger.
With the auger clutch engaged, there should be 1/32 to 1/16"
To adjust:
1.Loosen bolt holding the belt finger.
2.Rotate the belt finger around the bolt to the correct position.
3.Tighten bolt.
GB - 14
