EVS Toolroom Lathes | S E R V I C E | For Machines Mfg. Since 7/09 |
Feedrod Clutch
Adjustment
This lathe has an adjustable feed clutch that helps protect the drivetrain from overload. The feed clutch release point is adjusted at the factory. However, it can be easily adjusted depending on operator requirements.
Tools Needed: | Qty |
Phillips Screwdriver #2 | ........................................ 1 |
Hex Wrench 3mm | 1 |
To adjust the clutch release point:
1.DISCONNECT LATHE FROM POWER!
2.Remove the front and side feed access covers, as shown in Figure 133.
Feed Access Cover
Figure 133. Feed access covers removed.
3.Remove the clutch collar set screw, as shown in Figure 134.
4.Insert the hex wrench into the collar adjustment hole shown in Figure 135, and use the wrench to rotate the clutch collar.
—If you need to increase the release point, rotate the clutch collar upward.
—If you need to decrease the release point, rotate the clutch collar downward.
Collar
Adjustment Hole
Set Screw
Slot
Figure 135. Feed clutch set screw alignment.
5.Line up the set screw hole in the clutch collar with the closest set screw slot that is cut into the feedrod (see Figure 135).
6.Install and tighten the set screw so it is fully seated in the slot.
7.
