HEIGHTADJUSTMENTKNOB STORING
CLEANING & REPLACING FILTER
·Rotate the height adjustment knob to the correct carpet height. (Fig. 17)
·To clean bare floor, set this knob to the bare floor position and turn off the brush power switch. (Located on the top of the cleaner, see page 2)
Fig. 17
·After using the cleaner, store in upright mode.
·Store accessories on the storage clips located on the cleaner body.
·Wrap the cord around the cord storage hooks on the side of the body and hang
the plug at the cord clip on the wand.(Fig. 18)
Fig. 18
Cord
Clip
To optimize the vacuum performance you should clean the filter each time you empty the dirt cup.
·Lift up the dirt cup cover, rotate and remove the inner filter. (Fig. 21)
·Tap the inner filter on a trash bin to remove the dust from the pleats. (Fig. 22)
Note: This inner filter is washable and can be rinsed if you notice a reduction in vacuum performance (suction). To wash, first tap filter to remove excess dirt and dust from the pleats. Rinse filter clean with warm water then allow to completely dry (a minimum of 24 hours) before returning to dirt cup. Use filter: FLTB for inner dirt cup.
Dirt Cup Cover
Tap Gently
Cord 
Plug
CLEANING DIRT CUP
·You will need to empty dirt cup when dust reaches the “FULL” line.
·Turn off the cleaner and unplug from electrical outlet.
·Grasp the dirt cup handle and depress button, pull out the dirt cup from body. (Fig. 19)
·To empty, remove the dirt cup and hold over trash bin. Push the dirt release button and dispose of the dirt. (Fig. 20)
Dirt
Release
Button
- FULL | - FULL |
Body
Fig. 20
Dirt Cup
Dirt Cup
Release Button
Fig. 19
| HEPA |
|
| Inner Filter | r |
|
| |
Fig. 21 |
| Fig. 22 |
EXHAUST FILTER CLEANING & REPLACEMENT
·Pull out the exhaust filter. (Fig. 23)
·Replace the exhaust filter when it becomes dirty. (Fig. 24) Use filter: FLTA for exhaust filter.
Caution: This filter is not washable.
Filter Frame | Filter |
Exhaust
Filter
Body
Fig. 24
Fig. 23
Note: Replacement parts can be purchased by calling
8 | 9 |
