TOOL ASSEMBLY
· Attach crevice tool, dusting brush and upholstery
brush into storage area on the back of the vacuum. (Fig. 8)
| Crevice |
| Tool |
Fig. 8 | Dusting |
Brush | |
| Upholstery |
| Brush |
UPRIGHT MODE
USING IN UPRIGHT MODE
·Push the handle release pedal. (Fig. 9)
·Turn main power switch on. Turn brush power switch on.
Caution: The headlight and brush does not come on when in the upright position even if the switch is on. You must release the handle for the brushroll to begin spinning. (Fig. 10)
Base Safety
Switch
| Handle | Base |
|
| |
| Release |
|
Fig. 9 | Pedal | Fig. 10 |
|
CONVERTING TO CANISTER MODE
CONVERTING TO CANISTER MODE
·Remove hose from base hose connector. (Fig. 11)
·Step on release canister pedal and pull body upward by canister handle. (Fig. 12)
| Canister |
| Handle |
| Body |
Hose |
|
Base Hose | Release |
Connector | Canister |
| Pedal |
| Base |
Fig. 11 | Fig. 12 |
6
CONVERTING TO CANISTER MODE (cont.)
·Push handle removal button and pull up on handle to disconnect from body. (Fig. 13)
·Insert hose into handle hose connector and twist clockwise to lock in position. (Fig. 14)
·Push button on wand to extend telescoping wand. (Fig. 14)
·Insert end of handle into hard floor nozzle. (Fig. 15)
·Canister mode. (Fig. 16)
Handle
HandleHoseHose
Connector
Telescoping
Button
Handle
Removal
Button
Handle
Fig. 13 | Fig. 14 |
Handle
Hard Floor
Nozzle
Fig. 15 | Fig. 16 |
7
