For Machines Mfg. Since 7/09 | M A I N T E N A N C E | EVS Toolroom Lathes |
Changing Cutting Fluid
When you replace the old cutting fluid, take the time to thoroughly clean out the chip drawer, catch tray, and chip tray. The entire job only takes about a 1⁄2 hour when you are prepared with the proper materials and tools. Make sure to dispose of all old fluid according to local regulations.
Items Needed: |
|
| Qty |
Safety Wear ......See Hazards section on Page 62 | |||
New Cutting Fluid |
| 3 Gallons | |
Empty 5 Gallon Bucket w/Lid | .............................. | 2 | |
Phillips Screwdriver #2 |
| 1 | |
Wrench 3⁄4" |
| 1 | |
Disposable Shop Rags | Approximately 6 | ||
Hose or Tubing 5⁄8" x 60" (optional) | 1 Piece | ||
Magnets (optional) | As Many As Desired | ||
To change the cutting fluid:
1.Position the coolant nozzle over the splash guard, so it is pointing behind the lathe. If you have the optional hose, connect it to the end of the coolant nozzle now.
2.Place the
3.Turn the cutting fluid pump ON (or have another person turn it ON if you are holding the bucket), and pump the old cutting fluid out of the tank. Turn the pump OFF immediately after fluid stops flowing.
Running the pump without adequate fluid in the tank may permanently damage it. This is abuse and not covered by the warranty.
4.DISCONNECT LATHE FROM POWER!
5.Remove the vented cover shown in Figure 122 and slide the tank half way out of the base, as shown in Figure 123.
—If necessary, disconnect fluid hose from pump, where shown in Figure 124.
Note: The electrical conduit was purposely left long, so the tank can be removed without disconnecting wires from the pump. Do not disconnect electrical lines.
Fluid Hose
Disconnect 
Here if
Necessary
Figure 124. Fluid hose that may need to be
disconnected in order to remove tank for cleaning.
6.Pour out the remaining cutting fluid into your
7.Wipe up the layer of swarf/residue on the bottom of the tank and put the waste in the second
8.Slide the tank partially into the base and reconnect fluid hose (if removed).
Tip: Leave one or more magnets at the bottom of the tank to collect metal chips and make cleanup easier next time.
9.Refill the tank with new cutting fluid, then slide the tank completely into the base.
10.CONNECT LATHE TO POWER.
11.Open the valve on the cutting fluid nozzle.
12.Turn the cutting fluid pump ON to verify that fluid cycles properly, then turn it OFF.
Note: It may take a few seconds for the pump to start circulating fluid; however, if fluid does not start coming out within the first minute, turn the pump OFF so you do not burn out the pump motor. Try priming the pump manually by pour cutting fluid down into the nozzle, then repeat Step 13.
