Tips for Operation
Snow is best removed as soon as possible after snow fall.
To clear an area, run unit in an overlapping series of paths. For large areas, start in the middle and throw snow to each side, so snow is not cleared more than once.
ALWAYS direct snow away from area to be cleared and with direction of the wind.
TRAVELING
To travel from one work area to another:
1.Set Throttle to Slow or
2.Press down on handlebars enough to raise front of unit slightly off surface.
3.Disengage traction drive clutch and push unit to new work area.
TRANSPORT
ALWAYS shut off engine, remove key, and drain fuel when transporting unit on a truck or trailer.
Use extra care when loading or unloading unit onto trailer or truck.
Secure unit chassis to transport vehicle. NEVER secure from rods or linkages that could be damaged.
DO NOT transport machine while engine is running.
MAINTENANCE
Ariens Dealers will provide any service or adjustments which may be required to keep your unit operating at peak efficiency. Should engine service be required, contact an Ariens dealer or an authorized engine manufacturer's service center.
WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.
SERVICE POSITION
WARNING: Before tipping unit up onto housing, remove fuel so no spills will occur and remove battery (if equipped). Ensure unit is secure and will not tip over during maintenance.
Place unit on a flat level surface. Tip unit forward onto front of auger housing for service. Ensure unit is secure and will not tip over. Strap and clamp onto bench if needed.
Service Position
OS7125
Figure 8
GB - 13