2.8 CLEANING AND STORAGE
WARNING: AVOID SHARP EDGES which can cut. Movement of parts can cut off fingers or a hand. Wear gloves, and use extreme caution when servicing.
IMPORTANT: Never spray unit with water or store unit outdoors to help prevent sealed bearing rust or corrosion. Water can seep into sealed bearings and reduce component life. Bearings are sealed against dirt and debris only.
A unit that is excessively dirty should be cleaned before work starts. Cleaning will occasionally uncover trouble sources. Dirt and abrasive dust reduce the efficient work life of parts and can lead to costly replacement.
When taking unit out of extended storage:
1.Check for any damage or loose parts. Repair, replace, or tighten hardware before operation.
2.If a preservative fluid was used in fuel tank, drain and discard. Fill fuel tank with fresh new fuel.
ROTATING PARTS.
Keep clear of auger while engine is running.
• Read Operator’s Manual.
OS2080
•Allow operation only by properly trained adult, never children.
•Stop engine and remove ignition key prior to leaving the operator’s position for any reason.
•Keep all controls, guards and safety devices properly serviced and functional.
•Never direct discharge towards persons or property that may be injured or damaged by thrown objects.
2.9SAFETY RULES
Read, understand, and follow all safety practices in Owner/Operator Manual before beginning assembly or operating. Failure to follow instructions could result in personal injury and/or damage to unit.
ALWAYS remove key and/or wire from spark plug before assembly, maintenance or service. Unintentional engine start up can cause death or serious injury.
Complete a walk around inspection of unit and work area to understand:
• Work area • Your unit • All safety decals
ALWAYS check overhead and side clearances carefully before operation. ALWAYS be aware of traffic when operating along streets or curbs.
Keep children and people away. Keep children out of work area and under watchful care of a responsible adult.
NEVER allow children to operate or play on or near unit. Be alert and shut off unit if children enter area.
DO NOT allow adults to operate unit without proper training. Only trained adults may operate unit. Training includes actual operation.
Keep area of operation clear of all toys, pets, and debris. Thrown objects can cause injury.
Check for weak spots on docks, ramps or floors. Avoid uneven work areas and rough terrain. Stay alert for hidden hazards.
DO NOT operate near
Falling snow, fog, etc. can reduce vision and cause an accident. Operate unit only when there is good visibility and light.
NEVER operate unit after or during the use of medication, drugs or alcohol. Safe operation requires your complete and unimpaired attention at all times.
NEVER allow anyone to operate this unit when his or her alertness or coordination is impaired.
DO NOT operate unit without wearing adequate winter outer garments. Wear adequate safety gear, including safety glasses with side shields, and protective gloves. Wear proper footwear to improve footing on slippery surfaces.
DO NOT wear loose clothing or jewelry and tie back hair that may get caught in rotating parts.
Protect eyes, face and head from objects that may be thrown from unit. Wear appropriate hearing protection.
Avoid sharp edges. Sharp edges can cut. Moving parts can cut off fingers or a hand.
ALWAYS keep hands and feet away from all rotating parts during operation. Rotating parts can cut off body parts.
NEVER place your hands or any part of your body or clothing inside or near any moving part while unit is running.
ALWAYS keep hands away from all pinch points.
DO NOT touch unit parts which might be hot from operation. Allow parts to cool before attempting to maintain, adjust or service.
Never direct discharge towards persons or property that may be injured or damaged by thrown objects. Use extreme caution on gravel surfaces. Stay alert for hidden hazards or traffic. Adjust runners so scraper blade does not contact gravel. DO NOT use on gravel or crushed rock surfaces.
1 - 8