Date: February 26, 2014 No.
Replaces
ATTACHMENT CLUTCH/BRAKE ADJUSTMENT
WARNING: IMPROPER ADJUSTMENT could result in unexpected movement of auger and impeller causing death or serious injury. AUGER / IMPELLER MUST STOP within 5 seconds when Attachment Clutch Lever is released.
WARNING: Adjustment procedure requires the engine to be run with the belt cover off. AVOID INJURY. Read and understand the entire Safety section before proceeding.
Remove Attachment Cable Slack
(Figures 4 and 5)
1.Shut off engine, remove key, disconnect spark plug wire and allow unit to cool completely.
2.Loosen hardware securing belt cover to unit.
3.DO NOT completely remove the hardware from unit.
4.Remove belt cover.
5.Loosen jam nut on cable adjustment barrel, and then turn the adjustment barrel down to shorten cable and remove all cable slack (Figure 4).
1
2
3
1. Attachment Clutch Cable |
|
2. Cable Adjustment Barrel |
|
3. Jam Nut | Figure 4 |
6.With the attachment clutch disengaged, check that the attachment idler arm lightly touches the frame (Figure 5).
7.Tighten jam nut on cable adjustment barrel.
Page 5 of 8
