removable without the aid of a tool.
Electrical connections
!Ovens equipped with a
Fitting the power supply cable
1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram).
2. Loosen the cable clamp screw and remove it, using a screwdriver as a lever (see figure).
3. Remove the wire contact screws
under the screw heads, respecting the colour code: Blue (N), Brown
(L) and
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load indicated on the data plate (see side).
The appliance must be directly connected to the mains using an omnipolar
!The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations.
Before connecting to the power supply, make sure that:
•The appliance is earthed and the plug is compliant with the law.
• The socket can withstand the maximum power of
the appliance, which is indicated on the data | AUS |
| |
plate (see below). |
|
•The voltage must be in the range between the values indicated on the data plate (see below).
•The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
!Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible.
!The cable must not be bent or compressed.
!The cable must be checked regularly and replaced by authorised technicians only (see Assistance).
!The manufacturer declines any liability should these safety measures not be observed.
DATA PLATE
| width cm 43.5 | |
Dimensions | height cm 32 | |
| depth cm 41,5 | |
|
| |
Volume | lt. 58 | |
|
| |
Electrical | voltage: | |
(see data plate) maximum power | ||
connections | ||
absorbed 2250W | ||
| ||
|
| |
| Directive 2002/40/EC on the label of | |
| electric ovens Norm EN 50304 | |
| Energy consumption for Natural | |
ENERGY LABEL | convection heating mode: | |
| = Convection | |
| Declared energy consumption for | |
| Forced convection Class | |
| heating mode: > Fan assisted |
This appliance conforms to the following European Economic Community directives:
-2006/95/EEC of 12/12/06 (Low Voltage) and subsequent amendments;
-2004/108/EEC of 15/12/04 (Electromagnetic Compatibility) and
subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments.
- 2002/96/EC and subsequent amendments.
3