Ariston OK 892EL P X AUS S, OK 892EL S P AUS Replacing the light bulb, Sliding rack kit assembly

• The stainless steel or enamel-coated external parts and

AUS the rubber seals may be cleaned using a sponge that

Replacing the light bulb

has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances.

• The inside of the oven should ideally be cleaned after

each use, while it is still lukewarm. Use hot water and

detergent, then rinse well and dry with a soft cloth. Do

not use abrasive products.

• All accessories - with the exception of the sliding racks

- can be washed like everyday crockery, and are even

dishwasher safe.

Lamp

Holder

compartment

Lamp

Glass cover

To replace the oven light bulb:

1.Remove the glass cover of the lamp-holder.

2.Remove the light bulb and replace it with a similar one: halogen lamp voltage 230 V, wattage 25 W, cap G 9.

3.Replace the glass cover (see diagram).

• We recommend that detergents are not sprayed directly

onto the control panel, but that a sponge is used instead.

!Never use steam cleaners or pressure cleaners on the appliance.

!Do not touch the light bulb directly with your hands.

!Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly

Cleaning the oven door

!The door of LED INSIDE models cannot be removed.

Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack. For more thorough cleaning purposes, the oven door may be removed:

1.Open the oven door fully (see diagram).

2.Use a screwdriver to lift up and turn the small levers F located on the two hinges (see diagram).

F

		A
Left	Right guide
guide rail	rail
B
	C	of
		Direction
		extraction

To assemble the sliding racks:

1. Remove the two frames,

lifting them away from the spacers A (see figure).

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you, lifting it out of its slot (see diagram). To replace the door, reverse this sequence.

Inspecting the seals

D

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are

at the bottom.

4.Finally, fit the frames on the spacers A.

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

!Do not place the sliding racks in position 5.

14