Precor P80 manual Required Tools, Performing the Assembly, To begin assembly

Assembling the AMT 17

Required Tools

⁵₁₆-inch hex wrench

⁵₃₂-inch hex wrench

#2 Phillips screwdriver

Rubber mallet

SAE standard socket set

Wire cutter

Torque wrench (calibrated in inch-pounds)

Performing the Assembly

DANGER Do not attempt to connect electrical power until all assembly procedures are complete and the console is properly installed.

Follow these steps to assemble the AMT base unit.

To begin assembly:

1.Remove the two side fasteners that hold the front frame tube to the shipping pallet and cut the tie wraps that secure the rear base.

CAUTION: Do not move the AMT off its shipping pallet without assistance. To avoid unnecessary movement of the foot plates, do not install the handlebars until you begin the next procedure.

2.Lift the rear base and roll the AMT forward while your assistant stabilizes the front base and guides it off the shipping pallet onto the floor.

Note: Begin assembly in the area intended for use.