Precor P80 manual Replacing Access Covers, Leveling the AMT, To replace the access covers

22	Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers
	Connect …	To …
	The console power	The power cable assembly
	cable
	The Ethernet cable	The eight-connector modular jack on the
		jack panel
	The television cable	The coaxial connector on the jack panel
		Note: This cable must be wrench tightened.

4.Repeat steps 1 through 3 until all three cables are completely installed.

5.Insert all cables into the cable clips on the center frame pillar just below the bottom of the center column. Use plastic ties to bind the cables together below the clips and to route them away from any moving parts.

Replacing Access Covers

After you install the console cables, you can return the access covers to their previous positions on the equipment.

To replace the access covers:

1.Snap the front cover back into place. Reinsert the two buttonhead screws you removed with the front cover, then tighten them using a ⁵₃₂” hex wrench.

2.Position the top column cover between the handlebars and the body of the AMT. Make sure that the sides of the top column cover extend over the upper edges of the body covers, then use the heel of your hand or a rubber mallet to tap the cover back into place.

Leveling the AMT

It is important that you level and stabilize the AMT properly every time you move it.

CAUTION: To eliminate movement, make sure the adjustable feet are in contact with the floor. Also, make sure that the unit sits on a flat surface. Adjusting the feet of the unit cannot compensate for extremely uneven surfaces.