ARRIFLEX 416 Quick Guide 05/2006, Page 12
Beeper, Backlight & RGB ARRIGLOW
Beeper
The 416 is equipped with a beeper which can sound when the camera is started
or stopped. The upper line of display mode 6 allows the user to decide whether
and when the beeper sounds and how loud (LS is shown for ‘loudspeaker’). The
left-hand bar shows the status of the start beep. The right-hand bar shows the
status of the stop beep. In each case, with the bar in the high position the beep
will sound, in the low position it will not. The fi nal digit is the volume, which is
adjustable between 0 (off) and 3.
Backlight
The lower line of display mode 6 controls the brightness of the control buttons
backlight. This can be set between 0 (off) and 3.
Changing the Beeper and Backlight settings
• Use the SEL button to select the digit you wish to change, which will flash.
• Use the SET button to change the value of the flashing digit.
RGB ARRIGLOW
The ARRIGLOW on the 416 gives the user a choice of frameglow colours.
Colours 1 – 8 are preset colours followed by U, which is user adjustable by
setting individual Red, Green and Blue values. The ARRIGLOW brightness is
adjusted with the + and – buttons above the camera display.
Changing the RGB ARRIGLOW colours
• Push the “+” DIMMER button on the camera left side so you can see the
ARRIGLOW in the viewfinder.
• Set the display to mode 7.
• Pushing the SEL button will make the ARRIGLOW number flash. Pushing the
SET button will now cycle through preset colours 1 – 8 and then user
adjustable colour “U”. Stop at the colour you like – no confirmation is
necessary.
• To change the user adjustable colour, push SEL again while U is flashing. The
SEL button will now cycle through the red (r), green (G) and blue (b) values of
the user colour. Pushing the SET button changes the flashing colour value from
0 (no colour) up to 16 (maximum colour).