Aruba Spa 2003 Escape manual Pump button, Light, Filter Cycle Programming, Celsius Or Fahrenheit

Pump button

The control panel button designated “PUMP” activates the pump when pressed. The pump sequence is low speed, high speed, off. The pump, when the “PUMP” button is manual- ly pressed, turns off after thirty minutes (a thirty-minute default).

NOTE: You will not be able to turn off your pump if your spa is in a filter cycle, heating, or in freeze protection (less than 52°F).

Light

The control panel button designated “LIGHT” activates the spa light when pressed. The light turns off after two hour (a two-hour default).

Filter Cycle Programming

Proper filtration is an important key to maintaining the clar- ity of your spa’s water. The filter system is designed for unsurpassed effectiveness at removing debris and suspen- sions from the water while the water is circulating.

By pressing the Heat key and the Program key at the same time, you can adjust your filtration cycle from the factory set- ting of 2 hours every 12 hours, in 1-hour intervals.

NOTE: If the water temperature does not drop the internal timer still operates the filter cycle to ensure proper filtration.

CELSIUS OR FAHRENHEIT

By pressing the Program key and the Light key at the same time you can change the degree settings from Celsius to Fahrenheit or vise versa.

AIR CONTROLS

There are two air controls beside the topside control panel. By turning these controls you may adjust the amount of air going to the jets. When fully open you are getting the maxi- mum amount of air for full hydrotherapy action. To reduce the amount of air coming out of the jets simply close the air controls.

13