The NetCam 8001 is supplied with a screw hole for tripod mounting. The screw hole is
located on the base of the unit, as shown below. The base plate of the NetCam 8001 is
similar, but is supplied with a ceiling or wall mounting plate instead of the tripod screw hole.
Wall Mounting the NetCam 8001 Ceiling Mounting the NetCam 8001
The NetCam 8001 is designed exclusively for ceiling/wall mounting and a special mounting plate is
supplied for the purpose. Screw the plate (screws not supplied) to the ceiling at the point of installation.
WARNING!
When installing the NetCam 8001 on the ceiling,
(1) check the position of NetCam 8001 need to be vertically 90 degree even. Any non-vertical setting will cause
abnormal PAN/TILT operation.
(2) check that the ceiling is strong enough to bear the weight of the camera plus the mounting plate. A weak fitting
could result in the camera falling and causing serious injury.
Please check for looseness in the camera installation mount at least once a year.
Please note that PAN degree -135° ~ 135°(Max120°/sec.) and Tilt degree -45° ~ 90° (Max120°/sec.).
Mounting Plate Information
3 Screw hole diameter: 6mm (1/4 in.)
Plate thickness: 1.6 mm (1/16 in.)
Note: The horizontal angle is important when you hang the product from the ceiling. Excessive
inclination may bring about abnormal rotation of the camera lens.
©2007 Asante Networks Inc., All rights reserved. NetCam are registered trademarks of Asante Network, Inc.
All other names may be trademarks or registered trademarks of their respective owners. Specifications subject to change without prior notice.
11