Asante Technologies 8001/P/W

WORKSTATION1

WORKSTATION 2

AdHoc networking mode

2. AdHoc: Point-to-point networking mode

This camera connects to other wireless devices via a wireless network when it is in the

AdHoc point-to-point networking mode; i.e. the product connects to other devices equipped

with built-in wireless connection function without the need to access from any AP.

Note: Where no IP address is assigned from the DHCP server, the system will set the

Link-Local Address automatically. However, it is not routable IP address in most

environments.

Note: Wireless LAN is very popular today, please note that user use the network camera is

recommended to use “1.5Mbps” or below bandwidth due to wireless connectivity’s are

subject to depend on the wireless signal strength from the location where network connect to

AP, building block signal, and all wireless traffic in single AP. All factors will significant impact

the quality for realtime streaming data such as video.

Unlike wired 100M/1000M Ethernet point to point throughput which give you a lot of

bandwidth room to use. Although WLAN technologies claims to have 54Mbps throughput, is

it a share bandwidth and condition usage network. Therefore, 1.5Mbps and 60% of signal

strength or higher are highly recommend. Above that bandwidth or low signal strength will

result packet loss, low frame rate, distort video image. Or you have to lower the frame rate,

video size or bandwidth.

Authentication Type:

Open System Authentication

Open system authentication simply consists of two communications. The first is an

authentication request by the client that contains the station ID (typically the MAC address).

This is followed by an authentication response from the AP/router containing a success or

failure message.

All other names may be trademarks or registered trademarks of their respective owners. Specifications subject to change without prior notice.