CARE AND MAINTENANCE INSTRUCTIONS
CLEANING THE DETERGENT DRAWER
1.Pull the drawer out as far as it goes then lift it up and pull it out completely, as illustrated.
2.Clean the drawer with a soft brush under warm running water. Do not put the drawer into a dishwasher.
3.Replace the drawer by tilting it into position.
CLEANING THE CONTROL PANEL
To clean the control panel, use only a warm, damp cloth. To prevent penetration of water into the door lock and electrical components, never spray water or cleaning solvents on the control panel. Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will scratch the finish and could remove the writing on the control panel. Some paper towels may also scratch the finish.
WARNING!
Never spray clean the control panel. You could damage the electrical components. Also, never use abrasive cleaners, scouring pads or paper towels on the outer surfaces because they will scratch the finish and they could remove the writing on the control panel.
CLEANING THE PIN TRAP
Your washing machine has a pin trap designed to trap pins, hairpins, coins and similar items. This trap should be cleaned occasionally. To do this, follow the steps below:
1.Make sure as much water as possible is drained out of the tub then turn off the power to the machine.
2.Using the flat edge of the liquid detergent partition piece, a flathead screw- driver or similar item, gently pry open the drain pump cover, as shown.
3.There is always a small amount of water in the drain pump area. Before you open the drain cover, place a shallow container, such as a pie pan, on the floor below the drain to catch the water.
4.Pull the small black
drain hose loose from its position on the door cover and let the water drain into the pan.
5. Unscrew the pin trap cover and lift it out.
6. You can now clean out any grit or small objects. You should also clean the pump rotor at the back of the pump housing.
7.Replace the drain cover and reconnect the drain hose securely to its position on the door.
REMOVING AN OBJECT FROM BETWEEN THE DRUM AND OUTER CONTAINER
Occasionally, a small item may fall between the drum and the outer container. Such items should be removed because they could corrode and cause rust stains on the laundry. To remove the item, follow the instructions below:
1. Insert a flathead screwdriver in the center hole in the paddle and carefully push it to the left.
2.Grip the paddle with your other hand and pull it toward you.
3.Lift up the paddle and remove the object.
4.Replace the paddle in its fixing hole with the
paddle clips are properly located in the slots and slide the paddle toward the back as far as it will go.
REMOVING HARD WATER STAINS FROM THE DRUM
If you live in an area with hard water, the washer drum may become coated with a
Page 21
