ASRock 865PE manual Onboard Headers and Connectors, IDE2

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!

FDD connector (33-pin FLOPPY1)

(see p.9 No. 20) Pin1 FLOPPY1

the red-striped side to Pin1

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector.

Primary IDE connector (Blue)			Secondary IDE connector (Black)
(39-pin IDE1, see p.9 No. 8)			(39-pin IDE2, see p.9 No. 7)
	PIN1	IDE1		PIN1	IDE2
connect the blue end						connect the black end
	to the motherboard					to the IDE devices

80-conductor ATA 66/100 cable

Note: If you use only one IDE device on this motherboard, please set the IDE device as “Master”. Please refer to the instruction of your IDE device vendor for the details. Besides, to optimize compatibility and performance, please connect your hard disk drive to the primary IDE connector (IDE1, blue) and CD-ROM to the secondary IDE connector (IDE2, black).

Serial ATA Connectors	These two Serial ATA (SATA)
(SATA1: see p.9 No. 11)	connectors support SATA data
(SATA2: see p.9 No. 12)	cables for internal storage
	devices. The current SATA
SATA1 SATA2
	interface allows up to 1.5 Gb/s
	data transfer rate.
Serial ATA (SATA)	Either end of the SATA data cable
Data Cable	can be connected to the SATA
	hard disk or the SATA connector
	on the motherboard.

1 9