# % $
! #
@
(Setting switch side)
0Cover
For protection against water drips. Slit the rubber cap on
this cover and pass the cable through the slits. ☞ P. 16
!Camera Connector (Female)
Connect to ^, the Male Connector on the camera.
@Drop Prevention Hook
Attach the Drop Prevention Wire & to this hook to prevent the camera from falling.
#Clamping Holes (x 4)
Attach the camera to a ceiling or to a Ceiling Flush Mount Bracket (optionally available) using these holes.
$[MACHINE ID] Switch
When an
camera. ☞ P. 15
%Setting Switches
Use these to set the PROTOCOL, etc. ☞ P. 14
&
^
*
⁄
) (
^Connector (Male)
Connect to !, the Female Camera Connector on the Ceil- ing Mount.
&Drop Prevention Wire
Attach this wire to the Drop Prevention Hook @ on the Ceiling Mount.
*Camera Clamping Bracket
In order to clamp the camera onto the Ceiling Mount, in- sert and tighten the Locking Screw 4 into this bracket.
(Lens
The lens cannot be replaced.
)Dome Cover
The dome cover is fragile. Take care when handling it.
⁄Camera Body Cover
Do not remove the camera body cover while the camera is installed on a ceiling. Doing so will cause the dome cover to fall down.
9