JVC TK-C676 Alarm Input Polarity, Make, Duration, Priority, Alarm Output, Alarm OUT1, Alarm OUT2

	Item							Function & Setting	Initial Value
ALARM INPUT ..		(Continued)
	POLARITY	Sets the polarity of the alarm signal inputs.							MAKE
		MAKE : Alarm signals are transmitted when point of contact is made.
		BREAK : Alarm signals are transmitted when contact is broken.
					MEMO
			When an item for the B&W is set to the ALARM 1 to 4, it is set to the MAKE mode even if
			“BREAK” is displayed.
	DURATION	Sets the length of an alarm operation once an alarm signal has been transmitted.							5s
		(Unit:second)
		Setting values : 5s, 6s, 7s, 8s, 9s, 10s, 15s, 20s, 30s or 60s
				CAUTION
			This item is invalid with the system using the RM-P2580. When using the RM-P2580, use
			item “ALARM TIME” instead.
	PRIORITY	Sets whether or not manual operation is accepted in case an alarm input is recog-							ALARM
		nized during manual operation of the camera.
		ALARM : Manual operation is not accepted when there is an alarm input.
							(Priority on alarm)
		MANUAL : Manual operation is accepted even when there is an alarm input.
							(Priority on manual)
				CAUTION
			This item is invalid with a system using the RM-P2580. With this system, the ALARM input
			is permanently given the priority.
ALARM OUTPUT ..		Sets the configuration of the alarm output terminals on the Ceiling Mount.							–
	ALARM OUT1	Sets the configuration of the Alarm output 1 terminal.							ALARM
		OFF				: Does not output an alarm signal.
		ALARM				: Alarm signal is output upon input of motion detection or an alarm signal.
		B&W				: Alarm signal is output when the camera enters the B&W mode.
		PRESET : Alarm signal is output when a camera moves to a preset position.
		AUX1 to 3 : Alarm signal is output when a corresponding AUX signal is input. (This
							is variable depending on the remote control unit in use.)
					MEMO
			● Since the ALARM OUT 1 terminal employs a mechanical relay, its operating sound may
					seem noisy in a quiet environment. In this case, use the ALARM OUT 2 or 3 terminal
					instead.
			● Sine the ALARM OUT 1 terminal employs a mechanical relay, the service life of the relay
					may be shortened if signals causing an alarm (motion detect signal, etc.) are applied fre-
					quently. The service life of a relay is 200,000 times of operation. The relay is a consumable
					part and a replacement is chargeable even before the termination of the warranty period.
	ALARM OUT2	Sets the configuration of the Alarm output 2 terminal.							ALARM
		OFF				: Does not output an alarm signal.
		ALARM				: Alarm signal is output upon input of motion detection or an alarm signal.
		B&W				: Alarm signal is output when the camera enters the B&W mode.
		PRESET : Alarm signal is output when a camera moves to a preset position.
		AUX1 to 3 : Alarm signal is output when a corresponding AUX signal is input. (This
							is variable depending on the remote control unit in use.)
	ALARM OUT3	Sets the configuration of the Alarm output 3 terminal.							ALARM
		OFF				: Does not output an alarm signal.
		ALARM				: Alarm signal is output upon input of motion detection or an alarm signal.
		B&W				: Alarm signal is output when the camera enters the B&W mode.
		PRESET : Alarm signal is output when a camera moves to a preset position.
		AUX1 to 3 : Alarm signal is output when a corresponding AUX signal is input. (This
							is variable depending on the remote control unit in use.)

25