Emerson CF1AB01, CF1WB01, CF1PW01 owner manual How to Wire Your Ceiling Fan

NOTE: CEILING COVER,
SUPPLY WIRES AND	OUTLET
FAN WIRES OMITTED
	BOX
FOR CLARITY.

	HANGER
	BRACKET
Figure 14	HANGER BALL/
	DOWNROD ASSEMBLY

!WARNING

To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and the hanger bracket.

2.Securely connect the fan motor white wire to the supply white (neutral) wire using wire connector supplied (Figure 15). Securely connect the fan motor black wire and blue wire to the supply black (hot) wire using wire connector supplied (Figure 16). After connections have been made, turn leads upward and carefully push leads into the outlet box, with the white and green leads on one side of the outlet box and the black and blue leads on the other side of the outlet box.

!WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

How to Wire Your

Ceiling Fan

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.

1.Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation) (Figure 15). Securely connect wires with wire connector supplied.

!WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.

3.Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 16).

4.Lift the ceiling cover and the ceiling cover trim up to the threaded studs and turn until studs protrude through the holes in the ceiling cover and trim (Figure 16).

5.Secure the ceiling cover and trim in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied) (Figure 16). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod. Your fan is now wired to be turned on and off from the fan switch.

SUPPLY	BLACK AND BLUE
	FAN WIRES
GROUND WIRE
LISTED	WHITE SUPPLY
WIRE
CONNECTOR (3)	(NEUTRAL)
GREEN WIRE

1-1/4"

THREADED STUD

LOCKWASHER

KNURLED KNOB

Figure 16

CEILING

COVER

CEILING

COVER

TRIM

(GROUND) FROM	WHITE FAN
HANGER BRACKET	WIRE

GREEN WIRE	BLACK SUPPLY
(GROUND) FROM	(HOT)
HANGER BALL
	NOTE: CEILING COVER
	OMITTED FOR CLARITY.

Figure 15

NOTE: If you are using an Emerson Light Fixture with your fan, see Light Fixture Owner’s Manual for wiring.

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

7