Emerson CF1PW01, CF1WB01, CF1AB01 Using Your Ceiling Fan, Attaching Light Kit, Three-Speedswitch

Using Your Ceiling Fan

1.Restore electrical power to the outlet box by turning the electricity on at the main fuse box.

2.Check the operation of the fan by gently pulling on the 4-position speed control pull chain switch (Figure 17). The operating sequence is as follows:

REVERSING

SWITCH

SPEED

CONTROL

PULL CHAIN

THREE-SPEEDSWITCH

1st Pull—HIGH 2nd Pull—Medium 3rd Pull—Low 4th Pull—OFF

Figure 17

3.If airflow is desired in opposite direction, turn your fan off and wait for the blades to stop turning, then press the rocker switch located on top of the motor housing, and turn the fan on again. The fan blades will turn in the opposite direction and reverse airflow.

Attaching Light Kit

To install an accessory light kit, first unscrew the finial and remove the lower trim (Figure 18). Then remove the center trim by removing four 8-32 x 1/2” screws. Remove the threaded nipple from the center trim and install the light kit in accordance with the light kit Owner’s Manual.

!WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.

CENTER	SPEED
TRIM	CONTROL
	PULL CHAIN
8-32 x 3/8"	SWITCH
SCREW (4)
	THREADED NIPPLE
	LOWER TRIM

FINIAL

Figure 18

8