Assembly Instructions
1.Remove the fan motor and housing assembly from styrofoam packaging and position it so that the top of the motor is facing you.
2.Remove the hanger ball from the downrod by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 9.
PIN
HANGER BALL
DOWNRODSETSCREW
Figure 1
3.Separate, untwist and unkink the three motor leads. Route the motor leads through the downrod and seat the downrod in the motor coupling (Figure 2).
NOTE: If your ceiling height is nine feet or higher, you may use the
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 3) could result in the fan falling.
5.Install the setscrew (supplied) in the motor coupling (Figure 3). While pulling up on the downrod, tighten the setscrew using the setscrew wrench (supplied).
NOTE: The setscrew must be properly installed as described above, or fan wobble could result.
MOTOR LEADS 
(BLACK, WHITE, AND BLUE)
DOWNROD
FAN MOTOR AND
HOUSING ASSEMBLY
SETSCREW
WRENCH
DOWNROD
HAIRPIN
CLIP 
SETSCREW
MOTOR
COUPLING
CLEVIS PIN
WHITE LEAD |
| |
CONNECTED | DOWNROD | |
BROWN LEADS | ||
| ||
HAIRPIN | CLEVIS PIN | |
CLIP | ||
MOTOR | ||
CONNECTED | COUPLING | |
RED LEADS |
|
Figure 3
6.Screw two 1” threaded studs (supplied) into the motor (Figure 4). Leave approximately 7/8” of the stud extending above the motor. Slide the motor cover over the downrod and rotate the cover until the threaded studs protrude; install two lockwashers and knurled knobs (supplied) to secure the cover.
NOTE: Make sure the connected red leads, the connected brown leads, and the white lead are completely inside the motor cover and not pinched between the motor cover and the motor.
KNURLED KNOB
Figure 2
4. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 3). (Pin and clip are supplied in loose parts bag.) The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull up on the downrod to make sure the clevis pin is properly installed.
LOCKWASHER
Figure 4
4
MOTOR COVER
1" THREADED STUD 7/8"
MOTOR
