Emerson CF1WB01, CF1AB01, CF1PW01 owner manual Unpacking Instructions, General Information

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or accessories not designated for use with this product by Emerson Company could result in personal injury or property damage.

1.Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following:

a.Fan motor and housing assembly

b.One motor cover

c.One ceiling cover

d.One ceiling cover trim

e.Four blade flanges (14°)

f.Two blade flanges (20°)

g.One hanger ball/downrod assembly

h.One 18” downrod

i.One downrod trim

j.One decorative bulb

k.One hanger bracket

l.One upper cover trim

m.One lower trim assembly

n.One loose parts bag containing:

1.One setscrew

2.One setscrew wrench

3.Nine 10-32 x 5/8" oval head screws

4.Two 1” threaded studs

5.Two 1-1/4” threaded studs

6.Four knurled knobs

7.Four lockwashers

8.Five wire connectors

9.Seven 8-32 x 1/2" screws

10.One pull chain pendant and coupling

11.One hairpin clip

12.One clevis pin

13.Twenty-one 10-32 x 3/8" pan head screws

14.Twenty-one flat washers

NOTE: Place the parts from the loose parts bags in small containers to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

NOTE: Before discarding packaging material, be certain all parts have been removed.

FAN MOTOR AND

HOUSING ASSEMBLY

MOTOR

COVER

	HANGER BALL/
LOOSE	DOWNROD
PARTS	ASSEMBLY
BAG
	HANGER
	BRACKET
BLADE FLANGES
(2-BLADE VERSION)	CEILING
	COVER
	TRIM
BLADE FLANGES
(4-BLADE VERSION)

CEILING

COVER

UPPER

COVER

DOWNRODTRIM TRIM

BULB

LOWER

TRIM ASSEMBLY

18"

DOWNROD

DOWNROD TRIM

General Information

Your Cornerstone ceiling fan comes with two sets of blade flanges. One set (consisting of two flanges) allows you to use your fan with two blades, as the original 1895 Ceiling Fan was configured. The other set (consisting of four flanges) allows you to use your fan with four blades. Both sets of flanges, and the fan blades you selected, are patterned after the original 1895 Ceiling Fan. If your ceiling is nine feet or higher, you may use the 18-inch downrod, along with the downrod trim and decorative bulb, to further enhance the 1895 ceiling fan look.

3