You can set one of the standard values as listed for DDR3 memory mod- ules: [400MHz DDR3_800], [533MHz DDR3_1066], [667MHz DDR3_1333] and [800MHz DDR3_1600].
DRAM Voltage
Use this to select DRAM voltage. The default value is [Auto].
Memory Timing
|
|
| BIOS SETUP UTILITY |
|
| |
|
| OC Tweaker |
|
|
|
|
| Memory Timing |
|
|
|
| |
|
|
|
|
| ||
| Power Down Enable | [Enabled] |
|
|
| |
Bank Interleaving | [Auto] |
|
|
| ||
Channel Interleaving | [Auto] |
|
|
| ||
| CAS Latency (CL) | [Auto] |
|
|
| |
| TRCD | [Auto] |
|
|
| |
| TRP | [Auto] |
|
|
| |
| TRAS | [Auto] |
|
|
| |
| Command Rate | [Auto] |
|
|
| |
| TRC | [Auto] |
|
| Select Screen | |
|
|
| Select Item | |||
| TWR | [Auto] |
|
| ||
|
| +- | Change Option | |||
| TRFC | [Auto] |
| |||
|
| F1 | General Help | |||
| TRRD | [Auto] |
| |||
| TWTR | [Auto] |
| F9 | Load Defaults | |
| TRTP | [Auto] |
| F10 | Save and Exit | |
|
| ESC | Exit | |||
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
v02.54 (C) Copyright
Power Down Enable
Use this item to enable or disable DDR power down mode.
Bank Interleaving
Interleaving allows memory accesses to be spread out over banks on the same node, or accross nodes, decreasing access contention.
Channel Interleaving
It allows you to enable Channel Memory Interleaving. The default value for DDR2 is [Hash 1]. The default value for DDR3 is [Hash 2].
CAS Latency (CL)
Use this item to adjust the means of memory accessing. The default value is [Auto].
TRCD
Use this to adjust TRCD values. The default value is [Auto].
TRP
Use this to adjust TRP values. The default value is [Auto].
TRAS
Use this to adjust TRAS values. The default value is [Auto].
Command Rate
Use this item to change Command Rate Auto/Manual setting. Min: 1N.
Max: 2N. The default is [Auto].
36